Search results

Damn, people calm down! Why is it that every thread i open anymore, contains loads of pointless shit that barley hangs on to the subject of the thread? :naughty:

i know your said your wife isnt good at engaging a puck style clutch, but i have the RPS stage two six puck, and my mom can drive it perfectly, so... i mean i think it would hold what you say your planning on throwing at it, and there is ZERO chattering. This clutch feels more streetable than...

O, and have you had any experience with them?

Thanks, sounds like a good deal. Any other suggestions?

In Lexington, up towards roanoke and stanton. It dosent really matter where the shop is in VA, b/c it will be an easier drive.

Come on guys

Check out this place http://www.perfeng.cc/index.html, i talked to a guy there he told me he could get under 50RA spec, and no more than $120 for resurfacing the block and head... i think thats who im going to have to go to.

Ok guys, ive been searching for a while now and the only place that has given me a good answer is performance engineering in cleveland. are there ANY machine shops in VA or NC that can do a 50RA spec or lower???

Damn it, i knew i should have started the rebuild earlier!!!

Great start, now take all that money you are going to make the day you walk accross the stage in that cap and gown and put it in a damn bank account, or piggybank!!! Im attending school AGAIN, and i wish i had the $1,387 i had a year ago... it somehow vanished into thin air:wtc:

I have a stock CT, and i was planning on keeping everything at stock levels for about 1000miles, then just push it to whatever it can do.(profec B, and emanage)

Thanks man!

true, thats why im not going to touch the emange until the 1500mile is complete.

Sounds good also, i have the emanage blue installed but this was my plan... Total seal rings Classic race(not gapless), cryo treat the stock pistons, and typical MHG obligations, and hone. By the time the car is running again ill have a wide band, and the Profec B will finally be working again...

Sounds good, let me know how it goes. When do you think you will be up and running? When i start my rebuild(2-3 Weeks) i would like to know if its a line that shouldnt be crossed. Its makess me nervous, b/c its such a touchy subject.

I found this article as i was researching ring information. What are your opinions? http://www.mototuneusa.com/break_in_secrets.htm Thanks, Alex

HELL YES, set it up ill be there fa shaw!!!!!!!!!!

X-man, VERY impressive!!! Could i have a look see at the timing map? abwallace@unoh.edu O and before building with a forged setup, have you ever thought about cryo treating the stock peices?

Then how are peoplae using welds with only 5" backspacing?

I dont care, as long as they dont rub or anything, they'll be for track use so... What is back spacing really? How does it affect stance? What about these...