Well all its been sometime since I last posted but finally I've been putting my car together. So what fitting do I need to adapt my NA-T lines (1/8" NPT IIRC) to the turbo feed. Looks like some type of ORB fitting. Thanks.
Turbo feed on 7M-GTE
- Thread starter dumbo
- Start date
If using the stock turbo feed you will need this for -4an lines.
http://store.driftmotion.com/static/i-1jz2jz7moiloutletadapterfitting.php
http://store.driftmotion.com/static/i-1jz2jz7moiloutletadapterfitting.php
Damn your right it is a -4 insn't it? What kind of seal is the 12mm though? Still brass washer? Whats the thread pitch? It's the RabidChimp NA-T ct26 oil line kit. I don't theyv'e sold it for a while.
Are you using the oil pressure sending unit for turbo feed? That thread is BSPT. I am using a BSPT- -4 AN for my feed
Maybe I've been unclear, I was NA-T but now I am fully gte, but I want to use my NA-T lines. What goes into the turbo feed on a 7M-GTE block.
This is what you need if you are using the GTE Stock oil feed for the turbo and want to adapt it to your NA-T AN lines
http://store.driftmotion.com/static/i-1jz2jz7moiloutletadapterfitting.php Same as Hvyman posted
http://store.driftmotion.com/static/i-1jz2jz7moiloutletadapterfitting.php Same as Hvyman posted
Haha yes thank you, but what's the seal called? Thread pitch ect, if I go ask for a 12mm to -4 I'm pretty sure I'll get a stupid look.
Its 12x1.5 to -4an adapter. You will also need some sort of washer to seal it.
When i was looking around dm was cheaper. I also got parts from atpturbo as well. There prices are good.
Are you going to a local store?
When i was looking around dm was cheaper. I also got parts from atpturbo as well. There prices are good.
Are you going to a local store?