tps adjustment questions

[F_T_F]

im adjusting my tps as we speak. im following the TSRM and im a little confused. when i sez to turn the tps with the .70 mm feeler guage in between the stop screw and the lever am i looking for the ohm meter to read 0. or should i even have the multimeter set to read resistance

 

[theKnifeArtist]

yes, meter should be on K-ohms.
put the feeler gauge in whatever size it says, put the leads on the ones it says, and move the tps to get in within what is says.

 

[F_T_F]

yes, meter should be on K-ohms.

what about what the meter should read with the .7mm feeler guage

 

[theKnifeArtist]

i edited

 

[theKnifeArtist]

if you have little aligator clips, they make life a lot easier.

 

[F_T_F]

if you have little aligator clips, they make life a lot easier.

yea no kidding

 

[theKnifeArtist]

so hows that goin?

 

[F_T_F]

so hows that goin?

well my dumb ass was putting the feeler guage in the wrong location. now that i figured it out its all adjusted and in the process of being installed

 

[Alang]

in place of alligator clips to hold your meter lead tips to the tps leads, try placing short (1/4" or so) pieces of vacuum hose on the leads to hold your meter tips in place.