The driver seat in my parts car is power. I however cannot get it to move forward to remove the two bolts in the back, holding it to the car. I'm not sure if the motor in it is fried or if I am just not getting power to it, when i put the battery in, the interior lights will come on, but still no cooperation from my seat moving. Any suggestions, i really want this thing out of the car before i scrap it. Thanks.
Seat Removal Help
- Thread starter AjWit
- Start date
Try reseting the circuit breaker behind the drivers side kick panel. As I recall it controls all the power accessories.
^What he said. If that happens not to be the problem then check for voltage to the power seat it self. You can find wiring schematics for the Supra at the same website the TSRM is.
If you're scrapping the car and comes down to it. You could go underneath the car and drill out the bolts.
If all else fails and you don't want to drill the suckers out from underneath get a nice long (ratcheting is best) box-end wrench and be prepared to suffer a backache afterwards. Those bolts are a bitch to get out, but it's the route I had to go when removing mine since the car electrical was dead.
Find somebody with a plasma cutter,viola! your done
just gotta be careful not to slice the Supra
hope you have some friends with strong backs,that dam seat is heavy and cumbersome
just gotta be careful not to slice the Supra
hope you have some friends with strong backs,that dam seat is heavy and cumbersome
Power it with a battery and some extra wire:
http://cygnusx1.net/Supra/Library/TEWD/MK3/manual.aspx?S=Main&P=98
http://cygnusx1.net/Supra/Library/TEWD/MK3/manual.aspx?S=Main&P=98