Approx. how much would it be to port and polish the head? I'm just trying to get an idea of how much it would cost me to rebuild an engine.
Port and polishing
- Thread starter whudafux
- Start date
Sort of depends on the shop.
One of the Young guys took mine home with him and did it there so they were able to drop the labour costs quite a bit. (from $900 AUD to $500 AUD)
Normally I'd have done it myself but time was a factor and I couldn't be bothered with the mess!
One of the Young guys took mine home with him and did it there so they were able to drop the labour costs quite a bit. (from $900 AUD to $500 AUD)
Normally I'd have done it myself but time was a factor and I couldn't be bothered with the mess!
The N/A is blown and daddy is buying me a daily driver lol. So it'll give me time to get the turbo motor and completely rebuild it.
LOL it sort of goes like this>>dcrusupra87 said:
Open Drivers door insert Cash when full repeat on passenger side then open Hatch and fill up in there and then when you think you're done take the Targa off and yep ya can squeeze some more $$$ in !
N
NDBoost
Guest
add another name to the already huge list of supra owners that:
1.) Sink TONS of money into their cars
2.) Sit in their cars and pretend to drive
3.) Make Turbo Spool sounds randomly while walking around in public
4.) Kiss the car's hood and tuck her in bed (w/ a car cover of course)
5.) Talk about their supra constantly even though its not running
1.) Sink TONS of money into their cars
2.) Sit in their cars and pretend to drive
3.) Make Turbo Spool sounds randomly while walking around in public
4.) Kiss the car's hood and tuck her in bed (w/ a car cover of course)
5.) Talk about their supra constantly even though its not running
LOL yea ian after stuffing all that money in there then proceed to set in on fire and watch all your hard work and money go up in a blaze. HOorrayy!!!
::sigh:: im buying a honduhh
LOL! huge j/k
::sigh:: im buying a honduhh
LOL! huge j/k
4500 for head
hmm
1500 for a GREAT port job
1500 for custom cams
1000 for full ferrea valve train
minus well throw in another 1000 for beryllium copper valve seats
300 for bronze guides
300 for shimless buckets.
hmm
1500 for a GREAT port job
1500 for custom cams
1000 for full ferrea valve train
minus well throw in another 1000 for beryllium copper valve seats
300 for bronze guides
300 for shimless buckets.
520USD for a PP job over my way. Thats disassembly of the head and reassembly with valve adjustment.. not too bad if u ask me.
Hmmm...check this out:
http://cgi.ebay.com/ebaymotors/ws/e...=8041441466&rd=1&sspagename=STRK:MEWA:IT&rd=1
Extrude honeing/porting is about the best you can get...
http://cgi.ebay.com/ebaymotors/ws/e...=8041441466&rd=1&sspagename=STRK:MEWA:IT&rd=1
Extrude honeing/porting is about the best you can get...
Justin727 said:
How about instead of valve adjustment i send Ferrea +1mm valves, dual valve springs, titanium retainers, and spring seat locators instead and put those in place of the old ones. Would that cost me more money?
I hear in some parts of japan they released the swipe strip, which was hidden right beside the ebrake handle, so you could swipe your visa for faster cash loss. I've been looking into aquiring one for a few years.
eric
eric
N