Pic. Request: IC piping outside of car.

[empera]

i want to get some custom IC pipes done but i need to look at exactly which bends and pipes i will need. Problem is i want to run a aftermarket IC with inlets/outlets on opposite sides. If you can provide with pictures of you hardpipes out side of the car, it will be greatly appreciate.

Thank you.

questions? Comments? answers?

 

[kamil]

Not sure who's they are, but I found these pictures on my hard drive..

http://kahmeal.com/poopra/?gal=5

 

[rakkasan]

Not sure who's they are, but I found these pictures on my hard drive..

http://kahmeal.com/poopra/?gal=5

1st pic looks like cooleze pipes.

 

[empera]

thanks a lot kamil

 

[Mk3 TurboS]

OK This was my set up. I used 2.75" Stainless steel upper and 2.5" Aluminium Lower. For the upper I used 90' from IC, 45' through the snorkel hole. 2 more 45' and some 1m of straight pieces to get to the throttle body. I used only one joint near the snorkel. I also removed the 3000 pipe.

For the lower. 2 45' bends make the pipe that comes from the turbo. 90' bend to face towards your drivers side then some straight and a 180' to the IC.

Buy all the bends use some good gaffa tape and tape them together. mark them and then take them to a welder. ITS A PAIN IN THE ARSE!!!! mounting the IC is easy, getting the corect fitting pipes sucks. Good luck thou man, it is rewarding in the end.