New motor installed, no fuel wont start!

[PorterzSupra]

Got my new motor in and its getting spark but no fuel. I put a walbro 225 pump in during the install of the new motor but I hear the pump running but its not putting any fuel to the rail, I have a decent amount of gas in the tank I dont get it, the pump is running but no fuel... I cranked it over for about 6 minutes on and off does it maybe need some kind of prime or somethin since all the lines came off and the pump was out?? =(

 

[PorterzSupra]

ummm bump?

 

[suprahero]

I know you did, but did you check the lines at the top of the gas tank and make sure you hooked them back up? Just checking.

 

[PorterzSupra]

yea there all hooked up, I had the fule lines, injectos, fule rail FPR off so I think it has air in it or something I dunno

 

[suprahero]

I installed my new fuel pump yesterday as well as a new toyota oil filter while I was at it. When I got done I wasnt getting fuel either so I checked everything. The fuel pump wasnt coming on. The little connector had got something in it so when I snapped them together it didnt get a good connection. I had to take the gas tank back down and got it to snap together and it worked like a charm. Now I'm running just a little rich. I'm still working on that though. Good luck.

 

[IJ.]

yea there all hooked up, I had the fule lines, injectos, fule rail FPR off so I think it has air in it or something I dunno

It's a recirculating system Air would make no difference...

 

[diy guy]

bad fpr?

did you try pressurizing it with the line off?

 

[chevyeater]

You just put an adjustable pressure regulator on too? Where did you put the lines?

 

[PorterzSupra]

the tank line was crimped, its all set

 

[daledoe]

That would do it