Need help with my vacuum setup! (EGR, VSV)

[scotty]

Hi,

So, I need some help with my vacuum setup. All that's inside the marked red is what I'm wondering about.. as I've got a JDM there is no EGR. I do however have plugs for the two VSV on my USDM engine harness, does that mean I have to have both VSV connected? If so, can I then just block off the vacuum line(90999-92002 on picture)?

If not, what will I have to do then?

Scott

 

[scotty]

I think I need to bump this thread a bit. I'm still kinda unsure about this.

As I've got no EGR, where can I block the vacuum lines (that is supposed to go to the EGR)?

Thanks

 

[jetjock]

Remove the 80 mm one and cap it there. You don't need that VSV. The other VSV is not for the EGR.

 

[mk3_7m]

http://i3.photobucket.com/albums/y81/dirgle/Vac23.jpg

I'm not sure whether if you're supposed to block it or not. but this diagram should clear it up for you.

 

[aloshan]

exact same question.also do not have an EGR , how should my vacuum lines look?

 

[Donedreamin]

Can anyone confirm where the line goes from the powersteering pump?

 

[planemos]

Did you look at the diagram? The vacuum line for the power steering pump goes across the front of the engine.

 

[jetjock]

Connects to a fitting on the bottom of the accordion hose.

 

[Donedreamin]

Connects to a fitting on the bottom of the accordion hose.

Thanks brother!

 

[jetjock]

You're welcome. It also goes across the front of the engine