LC-1 Narrow Band reading for ECU Help

[OneJArpus]

How is this done? LC-1 Manual states that the analog -1 is for the narrow band reading and analog -2 for wideband reading. How would i hook up the analog 1 wire (yellow) for the ECU to use so i can get rid of the stock O2 sensor?


Would i cut the wire for the 02 sensor on the engine harness and wire up the yellow wire? or just tap in?

 

[Albert]

White wire on ecu. No tap

 

[OneJArpus]

ok thanks, i guess that was pretty simple

 

[gurley0916]

Make sure you ground out the other heater wires that remain because Albert and I believe that it is needed to tell the ECU that the 02 is plugged in (correct if wrong)...Also dont forget to program the unit so that it gives the narrow band signal on the AUX 1 output.

 

[Albert]

Yes what dingle dork said