Alright... so far the new parts ordered -
Fuel
--Drilled out J-Tube
--Walbro 255 going in
MAFT-Pro
--Speed Density Conversion
--Electronic Boost Control
--Air/Fuel Management
--(Mike's old setup - Arriving Tuesday)
Complete LARGE Spearco IC setup (Thanks, Aaron! Arriving Tuesday!)
--2.5" IC piping + couplers
--Greddy Type S knockoff
--Big ass Spearco style IC
3" Exhaust already installed, but going to be re-worked
--3" mandrels going in, for the catback section (and to tuck it up a little nicer)
--Bassani 3" muffler
--3" Elbow already in
Turbo!
--57trim CT26 (Shipping out from Jon @ MDCMotorsports Tomorrow)
--Planning on 14-16psi Boost (Felpro + ARPs on there right now)
Oiling System
--Summit Oil Filter Relocation Kit
--B&M Oil Cooler
--PermaCool oil cooler thermostat
Transmission
--R154 in good condition, that I want to rebuild before it goes in
--Complete Rebuild Kit from Jon @ MDCMotorsports
--XTD Stage III Clutch Kit (Arriving Tuesday from Aimco!)
----6 puck sprung clutch disc
----New Pressure Plate
----New T/O Bearing
----New Pilot Bearing - a little leery here, as I hope the crank is drilled for it already
----12lbs CroMo Lightweight Flywheel
Needed to still purchase:
New flywheel bolts
Braided SS clutch line
Hoping to have a whole new animal when I put her back on the road 2-3 weeks from now. Naturally, I'll document the process
OK, Flywheel bolts ordered (1.05/each from Toyota) They will arrive tomorrow!
Fuel
--Drilled out J-Tube
--Walbro 255 going in
MAFT-Pro
--Speed Density Conversion
--Electronic Boost Control
--Air/Fuel Management
--(Mike's old setup - Arriving Tuesday)
Complete LARGE Spearco IC setup (Thanks, Aaron! Arriving Tuesday!)
--2.5" IC piping + couplers
--Greddy Type S knockoff
--Big ass Spearco style IC
3" Exhaust already installed, but going to be re-worked
--3" mandrels going in, for the catback section (and to tuck it up a little nicer)
--Bassani 3" muffler
--3" Elbow already in
Turbo!
--57trim CT26 (Shipping out from Jon @ MDCMotorsports Tomorrow)
--Planning on 14-16psi Boost (Felpro + ARPs on there right now)
Oiling System
--Summit Oil Filter Relocation Kit
--B&M Oil Cooler
--PermaCool oil cooler thermostat
Transmission
--R154 in good condition, that I want to rebuild before it goes in
--Complete Rebuild Kit from Jon @ MDCMotorsports
--XTD Stage III Clutch Kit (Arriving Tuesday from Aimco!)
----6 puck sprung clutch disc
----New Pressure Plate
----New T/O Bearing
----New Pilot Bearing - a little leery here, as I hope the crank is drilled for it already
----12lbs CroMo Lightweight Flywheel
Needed to still purchase:
New flywheel bolts
Braided SS clutch line
Hoping to have a whole new animal when I put her back on the road 2-3 weeks from now. Naturally, I'll document the process
OK, Flywheel bolts ordered (1.05/each from Toyota) They will arrive tomorrow!
Last edited: