i cant speak english well but ill try...ok,my 92 turbo has a problem-i start the engine and the next moment it shuts down-when the engine is warm-then no problems:1zhelp: and the engine warning light is blinking-can someone help-thanx:1zhelp:
hello...
- Thread starter supercharged
- Start date
welcome! best bet is to use this page ->
http://www.cygnusx1.net/Supra/TechTips/engine_error_codes.aspx
to check why the CEL is coming on.
Check to see if your AFM is plugged in. The car will run but will stumble and die.
http://www.cygnusx1.net/Supra/TechTips/engine_error_codes.aspx
to check why the CEL is coming on.
Check to see if your AFM is plugged in. The car will run but will stumble and die.
yep check codes
1. open diagnosis port
2. get a short piece of wire
3. stick one end in e1 one end in te1
4. turn ignition to on
5. count the blinks on dash
you do pretty good for not knowing english
1. open diagnosis port
2. get a short piece of wire
3. stick one end in e1 one end in te1
4. turn ignition to on
5. count the blinks on dash
you do pretty good for not knowing english
Supercharged
you want to adjust the throttle position sensor using the following instructions.
http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?Section=FI&Page=101
you want to adjust the throttle position sensor using the following instructions.
http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?Section=FI&Page=101
supercharged said:
the throttle position sensor is on the throttle body which is on the driver side but attached to the intake manifold.
http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?Section=FI&Page=100
if you are turbo you want to look at the picture that says 7M-GTE
