Free dyno pull: Results.

[MK3Brent]

I made a 10.5 psi pull today and made 315hp 320tq.

Pretty decent baseline... I can't wait to turn the boost up.

Local shop had a grand opening and was offering free pulls!
The first pull I made was the 315... and I made another with the boost all over the place and it was pretty worthless.
So I'll definitely be getting back to the dyno.

AFR's were perfect on my WB, around 11.5 with pump 93.

 

[89Turbo]

nice man, what upgrades do ya have?

 

[MK3Brent]

Everything.

Short of a built motor and performance performance clutch.

 

[supradan22]

nice numbers for that psi time to turn up that boost.

 

[MK3Brent]

Yah, right now I'm looking at 350hp at around 15psi.

 

[SupraDreamPDR]

nice numbers man. are your valve cover breather holes routed to under the car with those stainless steel braided lines?

 

[MK3Brent]

nice numbers man. are your valve cover breather holes routed to under the car with those stainless steel braided lines?

Thank-you, sir.
Yes.

 

[oscolivar1]

nice numbers!!
how much does a dyno usually cost....just an estimate.....
i wanna do one but i dunno where one is and i live in virginia beach

 

[MK3Brent]

Well... this particular dyno shop was extremely expensive, 100 dollars for 3 pulls.

Most shops charge anywhere from 75 (lowest I've seen) to 85 dollars per 3 pulls.

 

[jkbmkiii]

very nice! I wish we had 93 at the pump here that would be awesome!

 

[MK3Brent]

With 5mm less than you, I think we made close to the same numbers for the boost pressure.

 

[malloynx]

i went to the dyno today as well>> i hit 500rwhp

anyway great numbers brent

 

[MK3Brent]

i went to the dyno today as well>> i hit 500rwhp

anyway great numbers brent

Yeah... with 1.7bar you ass!

Bring it on... next time I'll have a working EVC! :rofl:

 

[IJ.]

i went to the dyno today as well>> i hit 500rwhp

anyway great numbers brent

Down from last time Mike?

Brent: Well done!

 

[malloynx]

ehh i dunno what happened IJ. i was on a non load bearing dyno this time. and the boost was having trouble holding. also i'm working with the methanol and i was running in the 10's (AFR)

 

[IJ.]

45 hp could very well just be the difference in the dynos and calibrations ...

I always try to hit the same dyno and keep the variables to a minimum.

500 is still damn good at 1.7bar!

What compressor is on your Boss?

 

[malloynx]

67mm

 

[IJ.]

Ahhh ok so still quite a bit left in it then !

 

[malloynx]

yea, i'm still trying to run 29psi

 

[IJ.]

Should easily have enough Compressor for 29 PSI!

I think my 62mm is going to fall off the map by 30 PSI but we'll see in a few weeks!