Female Torx sizes for head and flywheel?
- Thread starter crrider80
- Start date
they arent torx heads, they are hex heads.
for the head, its 10mm. and FYI that is stock. ARP bolts use a 1/2inch 12 point head.
for the flywheel, im not sure what you have there.
torx:
hex socket for comparison:
i actually think that you can use torx drives in a hex head'ed bolt, but not the other way around.
for the head, its 10mm. and FYI that is stock. ARP bolts use a 1/2inch 12 point head.
for the flywheel, im not sure what you have there.
torx:
hex socket for comparison:
i actually think that you can use torx drives in a hex head'ed bolt, but not the other way around.
you can, even the stock ones. though you should replace them. but those are ARPs so you can reuse them.
those might be 1/2inch also, not sure.
those might be 1/2inch also, not sure.
lagged said:
I'm loacated in Queens, NY. I bought the car for $600 from some dude that lived in Staten Island but he kept the car parked at his job in Jamaica because it had a blown motor. He told me it had spun a bearing but I found out it threw a rod and punched a hole in the block :icon_conf . I surf supraforums (rs4buddy). Thats my friend's username I borrow it from time to time. I've pm'ed you regarding an engine previously (still interested btw just give me some time).
ts basically a stock exterior and gray cloth interior noting too special.
i agree, there is some life left on that disk. id replace it though, why not do it now while the job is easy? i personally HATE doing a clutch on the supra, its easy but i just dont like doing it.