Clutch problem ACT on a 7mgte with w58

[peter551984]

I have a supra 88 7mgte with a w58 from a non turbo supra... I have a act xtreme pressure plate with a act 4 puck solid disck... The car can start but it won't let me put any gear so I can shift at all.... they had given me this advices"
a. adjust clutch pedal
b. adjust clutch slave
c. adjust slutch pedal
Any ideas...

 

[24vtoy]

hello bud

i just posted this same problem a day ago

http://www.supramania.com/forums/showthread.php?170830-w58-with-double-diaphram-pressure-plate

sofar nobody has responded with accurate help

after sitting and thinking about it basically does your pressure plate sit higher up now ? you will need a lengthend releaser bearing by the mm difference between the 2 pressure plates.

maybe yours is not so serious ?

on mine i tried adjusting pedal aswell as lengthenin the rod on the slave cylinder and none worked

 

[supra13's]

Are you sure the clutch disc isn't in backwards?

 

[24vtoy]

here is what i did with the releaser bearing, added 25mm onto back as in pic on the right, now i do get clutch but i can change gears without pressing the clutch lol so think i added in too much

gona take off 15mm from this 25mm, this should be right

doing it this weeekend will let you know

 

[peter551984]

Are you sure the clutch disc isn't in backwards?

I put the clutch disk the correct way....

 

[peter551984]

Is there another way to make this work...
They told me to put some washer between flywheel and pressure plate or to adjust the clutch salve...

 

[24vtoy]

well start with that, make the rod longer on the slave and try it, u can use normal thread bar and cut it couple mm longer than the stock rod