Cam Position Sensor Resistance?

[JustinGotA1j]

My CEL has been coming on and off and the code reads that its due to my CPS. The wires off the sensors look to be fine(no fraying or cracks) and I was just curious if anyone knows the reistance values of these sensors so that I can check them to see what one isn't any good so I can replace it. Thanks.

 

[JustinGotA1j]

anyone?

 

[88YotaTurbo]

here you go bro. btw use the damn Toyota service repair manual GOD
J/K

 

[JustinGotA1j]

Awesome thanks. I was looking through the MKIV TSRM and it was something over 700 pages so I thought I would post here and see if someone could answer my question while I searched.

 

[JustinGotA1j]

Does anyone have the resistance values for the 1JZ or 2JZ Cam Position Sensor. Its only 2 wires not 4 like the 7M which is the picture that I was shown up top.

 

[88YotaTurbo]

ooops sorry man I didn't see the 1jz forum location. MY bad

 

[JustinGotA1j]

No worries. Having a hard time finding this info though so any help would be great.

 

[88YotaTurbo]

has anyone translated that 1jz manual yet?

 

[JustinGotA1j]

not to my knowledge. although i did find this the other day. Somebody might find it valuable for the bit of money they want.

http://soarercentral.com/sc-forum/messages/1812/107178.html

 

[Ken]

cold: 835-1400 ohms

hot: 1060-1645 ohms

 

[JustinGotA1j]

This might be a stupid question but I don't need the engine running to test the sensors do I?

 

[Ken]

no, don't run the engine.

 

[JustinGotA1j]

Thats what I thought since technically the sensor wont be hooked up when I ohm it out and there for car could run shitty.