BOV vacuum line question

[D-Supra]

I am in the process of completing a complete engine rebuild. I have searched and have not been able to figure out where the vacuum line that runs from the BOV across the top of the motor through the hard pipe in front of the 3000 pipe terminates. I know that it goes down between the valve cover and the intake. Where does this vacuum line connect to?

 

[suprajim54]

There's a hard pipe that runs between a couple of the intake runners. Then there's a short vacuum hose that will connect to the hard pipe assembly that goes toward the front of the engine with the VSV's. It's 25706 on this diagram: http://www.cygnusx1.net/Supra/Library/EPC/291420/catalog.aspx?F=1708&P=3

 

[D-Supra]

That is not the vacuum line that I am talking about. Looking at the diagram in the link below, I am wanting to know where the vacuum line goes that from the hard pipe (22206)? Follow that route that shows that it goes from there to 22230M through another hard pipe 22205 (which I do not have) to another vacuum hose (22230W). The diagram does not show where this last vacuum line connects to. This is where I am needing help.

I am talking about the smaller of the two tubes on the hard pipe. I cant figure where this line ultimately terminates.

https://www.google.com/search?q=7mg...d.php%3F54216-Stock-7MGTE-What-is-it;1024;768

 

[jetjock]

Scroll down then click to embiggen. Unlike the factory diagram this one makes it obvious:


http://www.akitarescueoftulsa.com/7mgte-diagram/

 

[atmperformance]

ones for you BPV and the other is evap

 

[cinderMK3]

I was also missing that hard pipe and power steering pump.

http://www.supramania.com/forums/showthread.php?216365-one-last-hurdle-on-the-engine-Vacuum-Question

check out the IMGs posted in it. maybe this will help too

On the bottom of the first page, I took pictures of my lines and that same pipe and where it routed right over top for viewing.

 

[suprarx7nut]

I briefly mention your line in question here too: https://www.youtube.com/watch?v=LK0JcZweJ64

 

[585Soup]

the vacuum line is held on by the same bolt that holds the coil pack ground.