Boost Controller Solenoid setup...

Justin · Dec 9, 2007

I'm finally getting around to installing the boost solenoid for the maft pro. Even though its about 23 degrees outside.

I lost the paper that came with the solenoid, so I just wanted to make sure I am hooking it up correctly before I cut my lines

IN : Compressor

OUT : Wastegate

annoyingrob · Dec 10, 2007

Sounds good to me. Worst case scenario, it doesn't work properly, and you swap them.

Justin · Dec 11, 2007

annoyingrob said:
Sounds good to me. Worst case scenario, it doesn't work properly, and you swap them.

Yeah, but if they don't work I have to go to the store and buy new hose, cuz one will be too short

Such a pain in the ass, I KNOW!

Thanks