Which output did you use for the LC1 into the Maft pro? One is setup correctly and the other is not.
The only reason I suggest this is because when I had mine hooked up incorrectly I was reading those types of numbers
heh, I had a Maxtor drive fail... no backups of the data or anything. It was really strange problem. I can't remember the details of the issue, but for some reason I thought the only problem was the circuit board, not anything internal.
I searched ebay for about a month before I found the...
I would also not use that style of fuse holder. I've ran into problems with that style many, many, many times. Instead, use a holder like this, its water proof, uses a more common style of fuse, and all around is just better.
Hey bud, I tried calling ya to help ya out over the phone... i'll go out and check now for ya though....
here ya go....
they were taken with my phone so i hope they're clear enough for you... i'll probably be up for another half an hour so if you need anything give me a ring.
I think I had about a total of 20 hours into mine from start to finish. In reality it took me damn near a year, but then again I have a real issue with finishing things once I start them.
I would not rate it as easy in the least bit. I suppose if you're putting 52mm in it'd be a lot easier...
I'm sorry, I meant messed with as far as tried to tune it, or anything to that nature.
I have gone through and set all the settings for the supra, and gotten it so the car should run well. I have not hooked it up to my laptop, or gone in depth with changing anything from default for the...
Yeah, I'll work on that... I honestly have not really messed with the maft yet, I was under the assumption(confirmed in the first two posts) that the car should run as it did before the install.
I'll figure out how to get the xdf file, and post it up.
The map sensor has its own dedicated...
Thanks for the replies guys, that's kinda the reply I was expecting (maybe I asked the question before? I dunno)
I guess I'll turn this into a diagnostic thread then...
Mods:
RonR short runner
Driftmotion IC
2.5 pipes all around
stock ct26
Aeromotive
rc 550's
walbro fp
12v mod...
when running a maft pro, with speed density, and boost control, if everything is hooked up correctly and all the settings are input correctly, the car should idle and rev the same it did before on the stock ECU alone, correct?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.