Recent content by trofimovich

More than half will say that it is expensive. :)

I assume that this is the exit of crankcase gases to the whistle in the frontpipe.

A pulley made from a single piece of aluminum, without a damper to dampen vibrations, can do a disservice. For some it works, for others it doesn't. To unscrew the pulley bolt, you need to hold the pulley itself so that the torque is not transmitted to the crankshaft. You need to make a device...

There is a reason to change it to ATI.

http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?S=FI&P=36 It is suitable? http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?S=FI&P=55

90915-YZZB2 could it be better?

TSRM. I studied well. Yes, thanks. I just thought that in the states, various engine repair shops are more common and there are ready-made forms for filling out. They turn out to be more practical or something, well thought out. Yesterday I already made a sketch of a homemade form for 7m. So I...

Well, or please tell me where, on what Internet site, I can download and print such forms? If anyone knows.There's something I can't find.

Guys, does anyone have printable forms for inspecting the crankshaft and the engine in general? You may have seen them from those who repair engines. Can you send it? I have quite a few spare parts accumulated and I need to carry out an audit and attach a sheet of paper with measurements to each...

Look for the gasket by thickness, not diameter. The piston does not extend above the edge of the block.

Did I understand correctly, Ekumaster employees tuned their ECU on the factory 7mgte engine? The fact is that there are no tuners in my environment and I want to transfer my factory 7M to ECU Motek M48 and I need base maps. It turns out I can use ECUmaster cards on my motor, but in another ECU...

Do you have a factory engine?Are basemaps from ekumaster suitable for factory engines?

If the factory pulley has not delaminated in the rubber layer, then you can continue driving. I bought the ATI pulley for myself because I’m going to install a dry sump.

Yes, I'm talking about private workshops.

We made a ventilation valve.